This all started after fitting a new clutch the push rod that was fitted looked old and worn, I only have cable adjustment there is no other way I can adjust the clutch. will I have any problems if I was to cut about an inche from the centre of the rod .drgaz said:Please can any one tell me if I should cut my new clutch push rod in half and fit a small ball bearing in the middle of the to ? the Rod I have is to long. Gaz
Well the bikes built up of many different parts like its a 57 frame with a 54 motor and a 52 g/box so finding the right parts is a problem any how I have resolved the problem by cutting the new push rod to the correct length and then re hardend the tip by heating to cherry red and letting it cool job done !Jason Curtiss said:drgaz,
I think you’ve stumped the panel.
Why is the stock pushrod too long?
Jason