Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Normal
What would you have done?Jean
What would you have done?
Jean
Machined a center in the bottom, or spigot, pushed up betwwen centres ,cut new thread and bearing surface , as long as it was't already to small, or machined it right out and pushed a new stem in place.
Chopper guys, 5mile stints between pubs is a big ride for them
And what applies the load to the bearings :?:
So an 1'' spigot on each clamp and a 2ba threaded rod between them to keep the bearing preloaded :?:
[/QUOTE]