breaking in new rings...wet or dry method?

Status
Not open for further replies.
Joined
Mar 19, 2005
Messages
696
As mentioned in the other thread, "smoke on one side", I will be doing a ring job this week. Did a look at the NOC website (UK), and saw there is now a different approach to installing/running in rings. Also ran into a website
http://www.mototuneusa.com/break_in_secrets.htm
that suggests a rather drastic way to break the rings in.

Any comments/suggestions before I do the deed and put the new rings in?

Thanks!!!!!!
 
I always oil the skirts but put the rings in dry, then when its warmed up ride it hard but watch that it doesn't get too hot. Never had a problem doesn't burn oil or smoke. If its put together right with correct clearances all will be well. I am sure the Brit manufacturers told buyers to run in for 1500 miles so by the time they opened it up and it went bang their 3 month warranty had expired :-)
Regards
 
hewho,

I always lubricate the rings, piston and cylinder bore with a thin coat of oil when I rebuild the top end of an engine; this has worked well for me for many years on all sorts of engines. The key, as snakehips said, is to get a proper cylinder bore and hone job. It is imperative that the finished bore match the requirements of the new piston.

And don't overlook proper ring installation.

Regards,

Jason
 
Status
Not open for further replies.
Back
Top