Belt drive noise issue...

Fit two adjusters ? Hymph. Used to tighten top crossbolt , when set , then pre tension adjuster against it , to stop rear chain pulling it across the slack .
Point being the load taken on the adjuster , as the large bolt can still crawl on a bad day . Best thing since sliced bread , these belt drives . Do they RUST
though , with NO Oil . ? :|

Got it aligned (ish) using two carpenters squares by tightening the chain up to pull it into alignment. Voila no more squeaking (so far). I think I may still fit a left side tensioner - as it will stop it wandering under torque.

Thanks for all the help guys.