Any ideas where this is from....

kev · May 7, 2024

Was out on the CR last week and found this in the driveway. Not saying it's definitely from the bike but does look like fasteners used on the bike so I'm curious to see if anyone recognises it....

The thread is 15mm long and the diameter is 3mm (ish).

Hopefully someone will recognise it and save me a heap of time scratching around the bike!!

marshg246 · May 7, 2024

One of the three that holds the head steady to the head.

kev · May 7, 2024

Sounds serious....

baz · May 7, 2024

marshg246 said:
One of the three that holds the head steady to the head.

This is a 961 question

concours · May 7, 2024

baz said:
This is a 961 question

3mm

TonyA · May 7, 2024

Did you mean M3 or M6 fot the bolt size and what length ?

kev · May 7, 2024

M3 - 15mm thread length

TonyA · May 7, 2024

Those are used on IAC holder and IAC cap also look at headlamp brackets as on mine some small screws are used on the fly screen bracket.

kev · May 7, 2024

Can you point me in the direction of the IAC? Where exactly is it located?

concours · May 7, 2024

kev said:
Can you point me in the direction of the IAC? Where exactly is it located?

Intake
Air
Control

Look on the throttle body (generic EFI logic)

kev · May 7, 2024

amazing - thank you. Will take a look after work

TonyA · May 7, 2024

kev said:
amazing - thank you. Will take a look after work

Look in this area closely , the TPS also has screws this size and maybe the MAP sensor .

https://www.accessnorton.com/attachments/full-jpg.72307/