AN Centestand Kit?

Tornado

VIP MEMBER
Joined
Dec 5, 2017
Messages
5,067
Country flag
Has anyone ordered the full centerstand kit for late model Commando? The pic shows everything except the two pivot bushes, are they included and just missing from pic or needing a separate item order?

Asking for a friend, eh!
 
Has anyone ordered the full centerstand kit for late model Commando? The pic shows everything except the two pivot bushes, are they included and just missing from pic or needing a separate item order?

Asking for a friend, eh!
It also fits the 72 Mk IV no issues. When retracted, the spring barely clears the oil filter, which was my only concern. The spring holes are drilled where they should be for this model. As far as I can tell, the geometry is correct because it doesn't flop
 
Has anyone ordered the full centerstand kit for late model Commando? The pic shows everything except the two pivot bushes, are they included and just missing from pic or needing a separate item order?

Asking for a friend, eh!
I've ordered them many times. They come with the older and newer pivots. The newer pivots are much better than the older ones but converting is a PITA.
 
Another question on the AN CS kit....the friend has it in hand now...new CS included....Are the shouldered pivot bushes for the later model bike? They do not seem to fit the stand pivot holes...
 
Another question on the AN CS kit....the friend has it in hand now...new CS included....Are the shouldered pivot bushes for the later model bike? They do not seem to fit the stand pivot holes...
If the shouldered bushes fit the cradle, then they are the ones to use. The stand in the kit is power coated. You'll have to scrape the powder coat out of the stand holes for the bush to fit.
 
Yes, the stand should pivot on the wider section, the narrower section should fit in the cradle hole so it's wrong as you have it in the picture.
 
Yes, the stand should pivot on the wider section, the narrower section should fit in the cradle hole so it's wrong as you have it in the picture.
Seems wider section will not fit in stand hole...i suspect its the powdercoating in the hole needs grinding back.
 


Write your reply...
Back
Top