5 bolts that mount engine/trans to frame

Status
Not open for further replies.
Joined
Jul 23, 2020
Messages
48
Country flag
I'd have to look again at my 69 norton, but I believe it is 5 different length/diameter bolts. I for the life of me, can not find them on Andover's site and I've been away from my parts manual for two weeks. Would like to order new ones as the bolts that came with my basket case were pretty chewed up.

Can anyone help me find the part numbers for these bolts? Again, they are what bolts the drivetrain to the frame, nothing else AFAIK.

Thank you!
 
Are these what you are after? They are studs, not bolts, but bolts can be used. This is from a 1971, but your 1969 should use the same parts.

2020-10-15_15-27-15.png

Front:
2020-10-15_15-34-44.png


Rear:
2020-10-15_15-30-26.png



Hope this helps.
 
Absolute ace you are. Thank you! I know I have seen that diagram before. Where did it come from?
 
Sorry for the PM,did not see your post at first maylar. these are exactly what I need
 
Studs work better than bolts since you can remove them without removing the inner primary cover if one breaks. Ask me how I know.
 
I'd have to look again at my 69 norton, but I believe it is 5 different length/diameter bolts. I for the life of me, can not find them on Andover's site and I've been away from my parts manual for two weeks. Would like to order new ones as the bolts that came with my basket case were pretty chewed up.

Can anyone help me find the part numbers for these bolts? Again, they are what bolts the drivetrain to the frame, nothing else AFAIK.

Thank you!
The pedantic response could have been there is one bolt and one stud that mount engine and trans unit to the frame, through the Isos. There are 5 studs that mount the crankcase to the front Iso bracket (2) and the cradle (3), and 2 that mount the gearbox to the cradle, but since you now know what you are looking for...good luck!

LAB must have been busy elsewhere. ;)
 
Status
Not open for further replies.
Back
Top