1970/71 Norton Commando Fastback left hand sidepanel.

Hi Guys,
This has been covered many moons ago but I can't seem to find the answer to the actual removal of the left hand side panel.As it stand the top metal studs are located on a straight piece of steel bolted to the frames webs left and right.To this piece of metal there are 2 L shaped pieces of threaded rod of which the straight end is threaded for a captive nut.The L shaped piece is the part that fits into the rubber bushes on the side panels metal loops.This arrangement was not set up correctly on the bike as the panel was a nightmare to remove.My question is once the fastener at the bottom is released should the panel pivot upwards or is it removed completely by either sliding it left or right off the rubber bushes that ard located in the back of the side panel.Can someone advise please.The panel is steel.

When the lower fastener is released the panel should then slide off the pins to the left.

Thanks for that,I,ve seen these before but could,t find the links for them.I guess what Ive got on my bike is some sort of aftermarket bracket maybe supplied by RGM/Norvil.Maybe the reason these brackets you've shown aren't used on my bike is because its a later frame and the original mounting points for these don't exist.Just a thought.

1971 Fastback has a different side panel.