MLW
VIP MEMBER
- Joined
- Apr 19, 2012
- Messages
- 19
I am in the process of setting up the stack height for the clutch for my new RGM belt drive kit to go into my Commando and ran into some issues. First I have tried emailing RGM and they haven't responded and when calling them I can hear them but they can't hear me. The issue started when assembling a 5 disc clutch pack into the new drum I had to force the retaing ring in place with pliers, I experienced ne such issues with the stock chain drive drum with the same clutch pack. Once assembled the spring was very much in a convex position as oppoesed to the correct slightly convex possition as indicated elsewhere in this forum. The spring does assume the correct position with the original chain drive drum. Investigating further, I compared the measurement from the bottom of the drum to the retaining ring groove. With the supplied 4mm plate at the bottom of the belt drive drum, the belt drive drum is 3mm less than the chain drive drum. The instruction say that the 4mm plate is in addition to the standard clutch stack but I can't see how it could fit with that difference in depth. Has anyone else run into this issue, am I avorlooking something. Any help would be appreciated.