Oh that was a bit alarming, I thought you were describing another vasectomy.He used to use a press and crow bar. Pretty horrible to watch, but effective.
Oh that was a bit alarming, I thought you were describing another vasectomy.He used to use a press and crow bar. Pretty horrible to watch, but effective.
Holy smokes guys haha, I never got a notification that anyone replied. I thought I'd check only to find 4 pages of levelling commentary.
Ya, I purchased the frame. The seller dropped it off at a family members who handed it over yesterday. I haven't given it a thorough look over, but obviously the down tubes are pinched. So I have a couple options. 1) I have a solid machinist in town that I trust to rectify the pinches 2) take the frame over to Redline Norton who has a frame jig.
I'll likely take it to Redline. The travel time and costs are high, so will need to wait until I'm travelling in their direction.
Cheers
Dan
We've moved on now.
What we really need to know now is, does the frame have a TITLE? If not, then WHY NOT?
In all seriousness though, with respect, a machinist is the wrong craft to work the crushed down tubes. A very talented fabricator is the person who can repair that.
Cheers
I'm having a little trouble following. Where am I drilling the hole?You can pull dents like that out
Make a die from a split tube with the correct ID to fit over the down tube
Drill a large enough hole to clear the dent
Tack weld a stud in the centre of dent
Then using a bridge you can pull it out, heating if required
The hole is drilled in the dieI'm having a little trouble following. Where am I drilling the hole?
Show this to your fabricator, he will understand.I'm having a little trouble following. Where am I drilling the hole?