starting sequence

Swingarm bushes. ..iso adjustment ...tire pressure...wheel alignment
Are the new isolastic units adjustables ?
Will check out all u said tomorrow, I think there is movement from side to side on swingarm , not sure if isolastics are adj what is correct tyre pressure I have 28 in front and 30 rear
 
Update folks,

With the new complete carb fitted she is starting and running perfect, it is a pity I did not get to the end of the issue , took bike on 100 mile ride averaging 60 to 75mph she went 100% with no issues apart from primary seal leaking it’s new by the way ffs, anyways she starts first or second kick every time hot or cold

Thank you all for ur guidance and thanks for not losing ur cool or taking the piss out of a newbie , anyways next task is to fix leak and install sump breather so I have no doubt I will be calling on ye again very soon , but for now Slainte agus go raibh maith agat
 
well mo chara , i trying to order the upgrade for the sump, quick one for ya, will it be easier to kick when installed, ?
 
well mo chara , i trying to order the upgrade for the sump, quick one for ya, will it be easier to kick when installed, ?
No ....But it may give you a touch of free power.. reduce the chance of engine oil seep/ leaks..clear excess oil from the crankcase quickly...(if sat for a while) and should give you better engine life all round. ..imo
 
Last edited:
well mo chara , i trying to order the upgrade for the sump, quick one for ya, will it be easier to kick when installed, ?
We had a VERY long, intensive thread just a short while ago on a "kickstarting bastard". 🤣

You must adapt to the machine. The machine will not adapt to you.
 
We had a VERY long, intensive thread just a short while ago on a "kickstarting bastard". 🤣

You must adapt to the machine. The machine will not adapt to you.
quick one for u buddy, fitting the reed breather kit to the sump will this make kicking her eaqsier ?
 
quick one for u buddy, fitting the reed breather kit to the sump will this make kicking her eaqsier ?
It will not, as mentioned above.
Perfecting your PROCEDURE will. Using the crankshafts inertia to overcome the compression.
 
Last edited:
Back
Top