Reed PCV valve

Status
Not open for further replies.
Is that something you make or is it "off the shelf" from some place?

Need to get something for my 850.
 
I "make" them by chopping them off cast-off Triumph air injection systems.
 
grandpaul said:
jaguar said:
Grandpaul, can you post a link to the "$25 Reed valve" that you recommended to me on CR.net?
Click to expand...
I thought it was in this thread, there are typically 2 or 3 crankcase breather threads happening at any given time on this forum.

Reed PCV valve


I have 5 or 6 on the shelf.
Click to expand...

Are those fasteners what I think they are?
 
Triton Thrasher said:
Are those fasteners what I think they are?
Click to expand...

They are the only screws I had with the right threads to mock it up at that moment. I have since installed proper button head stainless ones from Tractor Supply.
 
With mine, the lower right is threaded into where the cap thread would have been.
Seemed to be convenient. The upper left is a through bolt with a lock nut on the inside.


Reed PCV valve
 
No worries if it's a locknut.

Anyway, I thread the 2 holes in the case and screw the screws in from the outside.
 
Status
Not open for further replies.
Back
Top