Reply to thread

I would imagine  that general spacing,knurl  spacing , bend  spacing, bend diameter , degrees of bends, and the all important   tube clocking  are all very tricky, otherwise I might  try. I think I would go through a whole bunch of material before I got the hang of it and the bending equipment would set me back about  $500.


 the bars are 7/8" . 

Located in the USA.

That's real far  away but doable if I want to spend the effort ,time and money. Is there any web, contact info?



http://www.eastwood.com/professional-tubing-bender.html

[ATTACH=full]89562[/ATTACH]


Back
Top