I have picked up a primary cover that has had a poor job of hole drilling done on it .
The ones I have looked at that I like have some form of mesh attached & I am wondering how the mesh is fixed to the cover .
I will need to remove quite a bit of metal to clean it up , most of the raised circular sections & some of the center part .
I saw one where the mesh was held on by an external ring fixed to the cover .
Any experience or ideas would be greatly appreciated before I start hogging out material .
The ones I have looked at that I like have some form of mesh attached & I am wondering how the mesh is fixed to the cover .
I will need to remove quite a bit of metal to clean it up , most of the raised circular sections & some of the center part .
I saw one where the mesh was held on by an external ring fixed to the cover .
Any experience or ideas would be greatly appreciated before I start hogging out material .