- Joined
- Sep 29, 2013
- Messages
- 24
![Canada Country flag](https://www.accessnorton.com/images/flags/shiny/32/Canada.png)
Hey guys,
I did a small job on my engine head and I am putting every thing back together.
I am about to complete my primary case reassembling but if i look closer to the center stud, it seems that the inner case is not align properly by 1/16-1/8. I tried to fit the triplex chain and the alternator, but my rotor has the same problem with the stator.
How can I align the inner case? It sounds stupid, but can we « rotate » the engine by 1/16-1/8
regards,
phil
I did a small job on my engine head and I am putting every thing back together.
I am about to complete my primary case reassembling but if i look closer to the center stud, it seems that the inner case is not align properly by 1/16-1/8. I tried to fit the triplex chain and the alternator, but my rotor has the same problem with the stator.
How can I align the inner case? It sounds stupid, but can we « rotate » the engine by 1/16-1/8
regards,
phil
Last edited: