Wanted

Wanted Classic Motorcycles & Parts – Norton, Triumph, BSA & More

Wanted - Classic Motorcycles & Parts – Norton, Triumph, BSA & More

Browse or post wanted classic motorcycles & parts
Wanted , 1972 Fastback left side cover
Wanted Wanted , 1972 Fastback left side cover
jimbo
Expires
Views
436
061785
N
Wanted Commando Lucas alternator rotor
nonsense
Views
65
The inner part of the alternator that fits on the end of the crank. Looking for the non-exploding variety (part # NOT ending in 2006). Needs to still have strong magnets too (pass screwdriver test).
seanalex
Wanted Left side exhaust rocker arm
seanalex
Views
66
Hoping to find one available for a 750 commando. thanks
M-Hawk
Wanted Inner primary case wanted for 1973 Mk1 Norton Commando 850
M-Hawk
Views
58
England, UK
I'm looking for an inner primary case to fit a 1973 Mk1 Norton Commando 850. Has to be in good condition, with a good felt seal in situ. I'm in the UK. PM me if you have one, thanks!
jimbo
Wanted Looking for a set of NOS or used 850 bodywork-a roadster tank and side covers, Original paint
jimbo
Views
58
Long Shot Want; Looking for a set of NOS or nice used 850 bodywork-a steel roadster tank and pre MK3 side covers. Original factory paint stripes and decals, not repainted. (Or another long shot- a 850 steel highrider tank in orange, in the same condition) What do you have on the shelf...
J
Wanted Side Covers
Jack15T
Views
49
Boston, MA, US
Hi Folks, I'm looking for left and right side covers for a 74 850 Roadster. The part numbers are 06.4996 LH and 06.3504 RH. Metal preferably. Color doesn't matter. Thanks, Jack
M
Wanted 1970 or 71 good useable camshaft - commando
macvittiemotorcycles
Views
56
NC, US
Looking for a good usable 1970 or 71 commando end breather type camshaft that I can run without spending too much a new one. All eBay listings look rough
L
Wanted WTB Commando 750S side cover
Lorenzo
Views
54
I need an original blue metalflake side cover for my Commando 750S (or Early Roadster). I need the Right Hand one, but I will consider also the set.. Thank you for helping!
Dave Taylor head steady with spring needed
Wanted Dave Taylor head steady with spring needed
makrph
Views
54
Tony, WI, US
Working on my 1972 Norton Commando Combat, finished with front and rear isolastics along with new swing arm rebuild, just need to improve the head steady.
1971 Commando upper fork yoke with stem 06.1915 or 06.1917
Wanted 1971 Commando upper fork yoke with stem 06.1915 or 06.1917
GraemeH
Views
55
AT
I have bottom yoke part 06.1916 and am looking for the matching top yoke which has the stem attached. It is either part 06.1915 or 06.1917 Needs shipped to Austria in EU. Thanks
J
Wanted Hard to find bolt
Jack15T
Views
52
Boston, MA, US
Hi folks, I'm looking for a Bolt, Whitworth, 5/8-20, minimum of 1 inch long. I want to screw it into my Rotor Nut so I can attach a degree wheel on my 74 850. I need to verify my timing. I had o replace the primary cases and am unsure of the new markings. Thanks, Jack
Looking for this Interpol fairing fitted to a Commando
Wanted Looking for this Interpol fairing fitted to a Commando
jimbo
Views
62
Clinton, IA, US
Looking for this Interpol fairing fitted to a Commando .This type has the molded in pockets for blue lights. Also the blue lights and any other police pieces. Overseas finds are not a problem :)
concours
Wanted MK III Interstate right hand side panel cover wanted
concours
Views
54
I found a steel left hand cover at RGM. Still searching for a right hand. Thanks in advance.
S
Wanted Commando Rear and Front Axle Spacers
Super Seven
Views
50
Spokane, WA, US
Hi. I'm the process of converting a MK II Commando which had cast wheels for the 44 years its been in my family to wire wheel hubs (Unfortunately, the wheel I had built is an early non-cush drive hub). I'm looking for the spacers and lock rings, etc. for both front and rear wheels. Thanks...
F
Wanted clutch operating arm part # 040029 pre Commando
fireflake
Views
50
Walmsley, WA, AU
does anyone have a spare operating arm for a pre Commando box please,( 1962 model 50) David
Manxman or Alas fuel tank
Wanted Manxman or Alas fuel tank
ashman
Views
62
AU
Need a tank for my Manxman project, so a Manxman or Alas tank, I am not happy with the Alloy tank that came with this project bike. Ashley
1 watching
gatsby
Wanted Old rusty Interstate parts wanted.
gatsby
Views
59
NL, CA
Looking for an original Norton steal Interstate tank, silencers, pipes, seat, and side covers. The worse the condition (looking for rust), the better. It is for a mechanically sound “Rustoration” that I am planning. I’m interested in a trade or purchase. I have a lot of original parts to trade...
bsanorton
Wanted Interstate side covers for a 75'
bsanorton
Views
52
St. Augustine, FL, US
Need a set of Interstate side covers for a 75' that doesn't have the tool pocket on left side
Back
Top