Top Fork Bolts Removal and Installation

askdoctorday · Apr 19, 2013

Howdy- Two questions regarding installation/removal of the top fork bolts: 1) I've been using a set of plumber's bells to remove/install the fork bolts. Has anyone found a source for the proper size socket for this? It measures about 33.34 mm and I haven't been able to run one down. 2) Is there a specific torque value for tightening them, or is it just a snug 'em up tight kind of thing?

Any and all advice much appreciated as always.

Eric

john robert bould · Apr 19, 2013

I have lots of plate spanners , you can have one for postage costs,,you can view them on this forum some where.

Mike Sullivan · Apr 19, 2013

I got a socket to fit from Allwoods the Motor Factors (1/2" drive). John's sockets are also fine - I have one that was supplied with his excellent damper kit!

The MK III Workshop Manual indicates 30ftlbs for part #06-0345 (stanchion top chrome nuts), I just do mine up 'tight' ;-)

Mike

MKIII Commando

L.A.B. · Apr 19, 2013

askdoctorday said:
33.34 mm

= 1-5/16"

pete.v · Apr 19, 2013

A 34mm works just fine.

kevbo82 · Apr 19, 2013

i found an 1 5/16" socket at ace hardware, it was 3/4" drive so i had to use an adaptor at home. my dad also had a great little wrench in his norton tools, it's a really flat 9/16" ,right angle on one end (perfect for fitting in and getting those fork nuts off) and the straight end is a perfect fit inside the chain guard to undue the shock nut.

concours · Apr 19, 2013

A 1-5/16" six point socket is a good fit. Be sure to grind the chamfer off the socket so it grips the shallow nut well.
I have one of these as well: http://www.mscdirect.com/product/81727190

askdoctorday · Apr 21, 2013

Thanks everyone- I found a 1 5/16 socket, torqued it as specified. Thanks for all the help, as always.

Top Fork Bolts Removal and Installation

askdoctorday

john robert bould

Mike Sullivan

L.A.B.

Moderator

pete.v

kevbo82

concours

askdoctorday

Similar threads