Sticky throttle (help)!!

Stephen_Spencer · May 19, 2018

Hey guys,

Just cleaning Norrie Norton for a ride tomorrow, started her up to check the beautiful beast over and the throttle is not returning in the snappy fashion that it would normally do. It returns, but slowly. Like it’s binding.

Dual cable system is pretty basic, not sure that there is much to go wrong there. Can’t see that I have disturbed anything during my clean.

Anybody any ideas as to my my throttle is nor closing/snapping back as should be the case.

Any assistance would be gratefully received - hoping to ride tomorrow!

Thanks.

Steve
Sunshine Coast

pingu-nz · May 19, 2018

Steve
there is a wee hole in the plastic on the throttle ,give it a squirt of wd 40 and it should free up the throttle .

Which way you heading for the ride, if your coming south let me know

cheers
Paul

Stephen_Spencer · May 19, 2018

Hey Paul,

Good to hear from you, hope everything is going well. I will try the throttle WD 40 trick. Just read Richard throttle manual and spotted that little lubrication aperture.

Quick ride around the Sunshine Coast for breakfast at Kin Kin. Bit too far North for you Southerner! We will have to get together soon though and compare shiny bits!

Best regards.

Steve

pingu-nz · May 19, 2018

Stephen_Spencer said:
Hey Paul,

Good to hear from you, hope everything is going well. I will try the throttle WD 40 trick. Just read Richard throttle manual and spotted that little lubrication aperture.

Quick ride around the Sunshine Coast for breakfast at Kin Kin. Bit too far North for you Southerner! We will have to get together soon though and compare shiny bits!

Best regards.

Steve

Sounds like a plan

TonyA · May 19, 2018

You can disconnect the twist grip and cables at the twist grip. Remove the screws at throttle , work the cable ends off and see if the throttle body valves move freely and spring back ? Also lube under throttle sleeve .

Stephen_Spencer · May 28, 2018

Thanks Tony, I will try that I think. Lubricated with WD 40 which helped a little but the throttle is not returning freely as it should.

I’ll keep you informed.

Steve

contours · May 28, 2018

Did the same for mine to no avail. I think I need to cut more off the end of the new grip to solve my problem. But I do like letting go it from time to time to shake out the numbness in my hand.

richard-7 · May 28, 2018

contours said:
Did the same for mine to no avail. I think I need to cut more off the end of the new grip to solve my problem. But I do like letting go it from time to time to shake out the numbness in my hand.

Yes. Check the bar end caps

Stephen_Spencer · Jul 1, 2018

Sorry guys, never closed off this thread,

You guys were right of course, despite the fact that I had not touched the right hand bar end cap,it was that which was causing the binding. Loosened this and moved it out ever so slightly and all is back to,normal - DOH! Doh’nt know why I did’nt check that to start with!

Cheers

Steve
Sunshine Coast

contours · Jul 1, 2018

Solved my problem as well. I took a razor blade and trimmed the lip off the new grip and that did it. I appreciate the new anti-vibration grip even more now.

Sticky throttle (help)!!

Similar threads