re torque the head after run in on 74 850,

folks, i apologise for not finding the post i need so i had to post,
i am looking for a video showing the re torque on the head of my 74 850
i bought the off set spanners and the socket to do this
i have 300 miles on her now without any issue
she had a complete top end rebuild just want to torque her now and get out for a good blast
i ran her in exactly as required,i dont have one oil leak
appreciate any help folks thanks from the sunny southeast of Ireland

It shouldn't really need a video, just check the fasteners in the normal factory manual tightening sequence although using a torque wrench on some of the fasteners can be difficult if not impossible without an adaptor.

850 Mk2 would be the same as Mk3.

hi folks, i found the video so danger averted for now

thanks folks will give it a go this week

If it’s a composite gasket the chances are the fasteners will move quite a bit.

And if so, don’t forget to re set tappets as they’ll close up.