1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

N15CS Frame parts illustration

Discussion in 'Other Norton Motorcycles' started by Gilesy, Feb 22, 2019.

  1. Gilesy

    Gilesy VIP MEMBER

    Joined:
    Aug 27, 2017
    Does any one know if the above exists and if so where. I'm concerned at the position of some of the spacers and the swinging arm came with no end caps/covers. There are lots of excellent pictures on the forum but just not quite detailed enough. Thanks in advance, the non Norton aspect of this bike is a bit of a puzzle.
    Cheers
    Giles
     
  2. Yorkie

    Yorkie VIP MEMBER

    Joined:
    Jun 14, 2017
    I’ve got an assembled bike that has not been touched since the 70s. I could take some pictures of specific areas if you like.
     
  3. Gilesy

    Gilesy VIP MEMBER

    Joined:
    Aug 27, 2017
    Thankyou for that, I'm going to a large classic bike show tomorrow where I hope to find one to inspect, if not I will take you up on your kind offer.
    Cheers
    Giles
     
  4. pierodn

    pierodn

    Joined:
    Nov 10, 2012
    Hi.
    I have one completely disassembled, to mount.
    If you want pictures.
    Piero
     
  5. Gilesy

    Gilesy VIP MEMBER

    Joined:
    Aug 27, 2017
    Many thanks to both of you, my main issue concerned the spacer arrangement where the drive side rear engine plates are fixed the frame stem and the frame cradle. The drive side plate on mine was warped and the gearbox seemed just off square. Also there are no covers on the end of the swinging arm tube, so I was wondering how that works. Any pictures of these areas would be appreciated, many thanks
     
  6. pierodn

    pierodn

    Joined:
    Nov 10, 2012
    Hi.
    The spacers are welded on the plates, so that you cannot wrong with them.
    Piero
     

Share This Page