Had a small drip coming out through the bolts where the o rings were .

At first I thought it was the bushings because the o rings were new, but I think the spindles from these two gears when pushed stuck out from the front of the tranny case, sitting to proud of the o ring.

What I did was buff the front of them to make them shorter by a about 2 or 3 thou. I notice now that when I torque them down it is very hard to move.

What I did was use threadlocker and torque them just enough so the o ring will its job.

My question is I have about 2 thou movement which feels right but I wont know till its all together and running, so what is play, and is their a torque setting for those bolts.

thanks