| View previous topic :: View next topic |
| Author |
Message |
debby
Joined: 15 Apr 2004
Posts: 898
Location: Boulder, CO
|
 Posted: Wed Aug 11, 2004 7:24 pm Post subject: Still won't run... |
 |
|
...for more than a couple of minutes. I put my cleaned-out, un-stuck amals back on the bike tonight and tried it out. Tickled the carbs and it started 2nd kick. Ran well for a couple of mins then stalled. Wouldn't start without tickling again. So I re-tickled and it started right up and did the same thing.
It certainly seems like it's starving for gas. So I disconnected the fuel line and measured the flow from my nice new BAP petcocks. They seem to be clogging up just like the cheap chinese ones did. I collected 100cc of gas in 15 secs from one and about 80cc in 15 secs from the other. That's not much, the gas just trickles out, but it seems like it should be enough to keep the engine running at low rpm with no load. Could it be the low flow doesn't produce enough fuel pressure to make the float valves open? I'm just guessing but that's about all I can think of. The float assemblies are squeaky clean now and I really don't think they're sticking. But I suppose that's possible too. Opinions welcome!
Debby, ready to put a parts bike for sale on ebay |
|
| Back to top |
|
 |
Gerry
Joined: 11 Aug 2004
Posts: 1
|
| Posted: Wed Aug 11, 2004 7:58 pm Post subject: Carbs? |
|
|
Debby,
You don't mention the choke. Even with tickling (flooding) the choke should be about half-way on a cold engine.
Are the screens on your petcocks picking up any debris? If, they are clean, you should be getting plenty of gas. Pull the plug on the bottom of the float bowl, you should get a good idea of how much gas is actually in the carb.
Don't give up yet! |
|
| Back to top |
|
|
nortonfan
Joined: 24 Dec 2003
Posts: 362
Location: Brisbane, Australia
|
| Posted: Wed Aug 11, 2004 8:08 pm Post subject: |
|
|
Well, just another possibility.
You say it runs if you give it a tickle at the carbs again so.....
Is there any chance that the floats are getting caught on the edge of the fuel bowl gasket & only filling up when you force them down by tickling ?
As others have said before, things like this can be difficult to diagnose from afar.
Keep at it, you will sort it out, otherwise I am chasing some 750 barrells.  |
|
| Back to top |
|
|
illf8ed
Joined: 30 Dec 2003
Posts: 475
|
| Posted: Wed Aug 11, 2004 8:11 pm Post subject: Won't run |
|
|
Hi Debbie,
When a Commando is causing an unsolvable problem, they can be a real pain. It happens to all of us. Just walk away and come back much later.
Low pressure from the fuel lines won't effect the carb float bowls, they work off gravity. It really sounds like the floats are hanging up. The floats can get trapped by the bowl gasket. I would take one carb off and shake it up and down. If it doesn't rattle the float probably is stuck.
Before you do this, you might try tapping lightly on the bowl with a screw driver handle...just might free up the float.
My '72 has been running for 7 years after a complete restoration with very few problems. The Boyer caused some grief, but I took Dave Commeau's advise and replaced it with a Lucas RITA...much better. |
|
| Back to top |
|
|
Guest
|
| Posted: Thu Aug 12, 2004 6:47 am Post subject: Tank full of dried varnish? |
|
|
I just restarted a '72 that had sat for years. It probably had a 1/3
of tank in it that slowly evaporated. Every time I cleaned the carbs
and it would run for a few seconds. Each time I checked the
carbs they had varnish deposits. I took the tank off , filled it with a combo
of carb cleaner and gasoline, and shook ithe heck out of it.
I then dumped the contents out by turning the tank upside down.
Lots of varnish debris. Cleaned the carbs AGAIN and it now runs fine.
Hope this helps. |
|
| Back to top |
|
|
NortonPete
Joined: 27 Jul 2004
Posts: 3
Location: Northern New Jersey
|
| Posted: Thu Aug 12, 2004 6:50 am Post subject: |
|
|
The above reply was from me NortonPete.
I'll figure this out yet. First you log in.  |
|
| Back to top |
|
|
Jason Curtiss
Joined: 14 Jun 2003
Posts: 667
Location: HOUSTON, TEXAS
|
| Posted: Thu Aug 12, 2004 9:45 am Post subject: |
|
|
Hi Debbie,
Before you sell your bike on e-bay, try the following:
Make sure your gas cap is vented!
If your gas cap is vented and you continue to have the same symptoms, check to see if you have a fuel delivery problem by removing the carb drain plugs imediately after the bike stalls. If scant fuel comes out of each bowl, you have either a float problem or plugged petcock filters.
Remove the petcocks and inspect the filter socks. If they are plugged with gunk, clean the tank and petcocks.
If the petcocks are OK, check your float height.
With the float bowl upside down with foat and needle installed, the top edge of the float should be level with the top edge of the float bowl.
Let us know what happens.
Jason |
|
| Back to top |
|
|
debby
Joined: 15 Apr 2004
Posts: 898
Location: Boulder, CO
|
| Posted: Thu Aug 12, 2004 12:13 pm Post subject: |
|
|
with the float bowl upside down and my thumbs holding the spindle in place, the top of the floats do hang down a bit - I'd say 2mm or so - below the top of the float bowl. Could that contribute to the problem? They've been like that since day one though and I haven't had this problem until just a few weeks ago when it suddenly developed. I installed some new brake shoes in the pathetic front brake and thought I'd try a test ride to see if they helped. The bike had other ideas though and hasn't run since. Hmm, maybe I should put the old brake shoes back in...
Debby |
|
| Back to top |
|
|
nortonfan
Joined: 24 Dec 2003
Posts: 362
Location: Brisbane, Australia
|
| Posted: Thu Aug 12, 2004 12:21 pm Post subject: |
|
|
Debby,
Good to see you still have your sense of humour
Remember the basics that an engine needs,
compression, fuel & spark.
You did mention earlier that you did some drilling into your carbys ????
Is this area of your "fuel" requirement all OK ?
Just another thought to throw in the ring.
Sometimes I just threaten to sell mine & they behave properly |
|
| Back to top |
|
|
Jason Curtiss
Joined: 14 Jun 2003
Posts: 667
Location: HOUSTON, TEXAS
|
| Posted: Thu Aug 12, 2004 1:45 pm Post subject: |
|
|
Deb,
Your float level, if anything, sounds a bit on the rich side, so it does not appear to be your problem.
Did you check the gas cap vent? Start the bike and run it with the cap open slighlty and if it doesn't stall, you have a plugged gas cap vent.
What about the petcock filters, are they clear?
Jason |
|
| Back to top |
|
|
debby
Joined: 15 Apr 2004
Posts: 898
Location: Boulder, CO
|
| Posted: Thu Aug 12, 2004 7:34 pm Post subject: |
|
|
I went over to the Very Detached Garage after work today to try a few things. I removed a petcock - fuel screen was fine. Couldn't get it apart so I just put it back in. Fuel level in the tank was pretty low so I bought some more gas. That helped the fuel flow through the petcock but had no effect on the stalling problem. Neither did running with the gas cap open.
The next time it stalled out I quickly shut off the gas and removed a float bowl (these don't have drain plugs). Was full of gas just like normal. So I dumped the gas, hooked up the fuel line and turned on the tap holding the float bowl in my hand. It filled up and shut off just like it's supposed to.
So I don't know, it's the unsolvable problem. The last time the bike ran normally was July 5 (I've been keeping a maintenance log). Maybe it will never run again. Years ago I had a Ducati 250 single that died a similar death. One day it decided it wasn't going to start. My dad, my brother and I checked everything we could think of. Everything seemed normal yet the bike never ran again. This seems very similar. Anyone wanna buy a parts bike?
Debby |
|
| Back to top |
|
|
nortonfan
Joined: 24 Dec 2003
Posts: 362
Location: Brisbane, Australia
|
| Posted: Thu Aug 12, 2004 7:46 pm Post subject: |
|
|
Debby,
Most things are usually simple & u curse yourself after u find the problem.
I suggest you get some one with some years of norton experience.
My bet is they will find the fault within 30 minutes.
Let em find it for you, then buy em a beer or 3........
U will probably learn a new thing about nortons also.
DON'T GIVE UP !!!! |
|
| Back to top |
|
|
Jason Curtiss
Joined: 14 Jun 2003
Posts: 667
Location: HOUSTON, TEXAS
|
| Posted: Fri Aug 13, 2004 4:12 am Post subject: |
|
|
Debbie,
Are you sure you're not making this whole thing up in order to give us something to think about and discuss on the forum? If not, you've really stumped the panel.
Can you keep the engine running at higher RPMs? What do your spark plugs look like? If they are sooty (great name for a black cat) perhaps you have a peculiar electrical problem. Condensors can act strangely when they are faulty, but I assume you've replaced these.
Are the carburetors set up with the slides, needle position, jets, etc. as per factory recommendations for a 750 Commando.
How much do you want for this bike with mystery ailments?
Regards,
Jason |
|
| Back to top |
|
|
debby
Joined: 15 Apr 2004
Posts: 898
Location: Boulder, CO
|
| Posted: Fri Aug 13, 2004 5:23 am Post subject: |
|
|
The plugs do look rather black and sooty. Funny you should mention that as a cat name, the local shelter has a black smoke Persian up for adoption and that's his name! Cute kitty.
I've thought about replacing the condensers but haven't tried it yet. It looks like the hunt has turned back to the electrical side after ruling out all the fuel issues.
I guess the last resort will be to haul it down to denver, hand it over with a blank check to the brit bike shop, and let them have a go at it.
Or I could just sell it. Would be a great bike to put on display, looks very nice. Lots of good parts too. PM me if interested!
Debby |
|
| Back to top |
|
|
norbsa48503
Joined: 07 Apr 2004
Posts: 1035
Location: Flint, Michigan
|
| Posted: Fri Aug 13, 2004 8:55 am Post subject: |
|
|
| Debby, How did you fill in the blank off holes you drilled out? As I told you earlyer I have seen some very strange problems come from the blocking of these holes. The simtoms seem to indicate that your piliot curcit is running out of gas If you used old cut off air screws, are they blocking the pathway? New carb bodies and brass slides could be in your future. norbsa |
|
| Back to top |
|
|
|
Norton Commando Forum by Corporate Pages Web hosting using phpbb
The Unapproachable Norton Commando
At the end of 1967 the Norton Commando was announced.
The Norton Commando was greeted with a certain amount of scepticism because on first sight the commando appeared to comprise of the old Norton Dominator twin cylinder engine mounted at an inclined angle in a set of new cylinder parts.
It was not realized that the new Norton Commando Isolastic method of engine suspension damped out all engine vibration and produced a machine which had uncanny smoothness for a vertical twin. In due course the critics were silenced and the Norton Commando had the distinction of being regarded as the first of todays so called superbikes. There can be little doubt that the original design concept of the Norton Commando has proved correct, since comparatively few modifications of any real consequence have been made since production commenced during 1968.
Now nearly 40 years later Norton Commando riders like us are a breed of our own, and as far as we are concerned its still more fun to go for a blat on the old Norton Commando, and fast. As a Norton Commando owner and enthusiast, my goal here is to promote and give credit to those who keep the Norton name going.
It is more deserving to give credit to the Commando itself, for after all these years it continues to be respected. The original Commando designers like John Favill are those who deserve the credit for developing this incredible motorcycle.
The Norton Commando Roadster and Interstate of the late seventies, never died. Although the Norton Villiers factory dispersed the tradition lived on. Today Kenny Dreer in the USA is developing the new 952 CC Norton. What a great looking bike this is, and its engineering is still based on the original layout. It will be interesting to see how the new 952CC Norton does in todays tough motorcycle market. One thing is for sure, I would own one if I could afford it.
